Roofing Materials

Metal vs shingle roofing in San Antonio: which lasts longer

Metal outlasts shingles in San Antonio by decades — but shingles cost far less upfront and suit most homes here. The honest comparison is lifespan, hail behaviour and heat, not a single number.

By Juarez Contracting & Innovation LLC · Published · Updated

Metal versus shingle is the most common material question we hear in San Antonio, and the short answer is simple: metal lasts longer, shingles cost less. Everything else — hail, heat, wind, HOA rules — decides which one fits your house. The lifespans below are trade estimates, not measurements; no published study quantifies San Antonio shingle-life loss, so any page stating a single number without a range is overstating.

Here is the comparison on the facts that matter here.

The short answer: metal lasts longer, shingles cost less

Standing-seam metal runs 40 to 70 years in trade sources, with the most pessimistic Texas-wide guide at 35 to 45 years. Architectural asphalt shingles run a realistic 15 to 20 years in San Antonio, against a 25 to 30 year manufacturer rating. Three-tab shingles run about 12 to 15 years, and Class 4 impact-resistant shingles about 20 to 25 years. Metal costs substantially more upfront; shingles are the standard replacement for most San Antonio homes. The lifetime question is whether you will still own the home when the shingles need replacing again.

How long does each roofing type last in San Antonio?

Heat and hail shorten asphalt life versus the lab rating. UV breaks down asphalt binders and drives off oils, granules shed, and the shingle curls and cracks — south- and west-facing slopes age first. Metal and tile are far less UV-sensitive. Clay and concrete tile last 50 years or more as a material, but their underlayment fails at 20 to 30 years. Flat and low-slope membranes run a realistic 15 to 25 years. None of these figures is a guarantee; they are the ranges San Antonio trade sources agree on, and the spread itself is the finding.

What San Antonio weather does to each material

San Antonio averages about 110.6 days a year at or above 90 degrees, and 2025 set the record at 162 such days, with an all-time record high of 111 degrees on 5 September 2000. That heat, plus daily thermal cycling, loosens seal strips and fasteners over thousands of cycles. Hail is the sharper risk: about 85 percent of Bexar County hail reports of 1 inch or more fall in March, April and May, and the 12 April 2016 storm dropped hail up to 4.5 inches. Hail of 1 inch or more can damage asphalt shingles; metal typically dents rather than cracks. Wind matters too: the City's adopted code sets a design wind speed of 108 mph for homes inside city limits, and shingles carry wind ratings tested to ASTM standards — ask what rating a proposed shingle carries rather than accepting a generic "wind-resistant" claim.

Upfront and lifetime cost

No firm prices are published here, because no verified San Antonio price range was available for publication. What is certain is the shape of the comparison: metal costs more upfront and lasts two to three times as long; shingles cost less upfront and will need replacing again within 15 to 20 realistic years. Compare written, itemised estimates that list tear-off, underlayment, flashing, permit and cleanup — and remember a re-roof permit costs $28.75 flat, or $31.05 filed online with the City's surcharges. A cheap estimate that omits tear-off or flashing is not a cheaper roof.

Heat, hail and wind: performance differences that matter here

  • Heat. Metal reflects more heat, especially in light colours or cool coatings; dark asphalt absorbs it. Attic ventilation and insulation matter as much as the material.
  • Hail. Class 4 impact-resistant shingles, tested to UL 2218, are the shingle answer to hail. Metal is the most hail-tolerant common material. Tile resists hail as a material but individual tiles crack under large stones.
  • Wind. Both materials can be installed to perform at the City's 108 mph design wind speed when the right rated product is used and installed to the manufacturer's instructions.
  • Weight. Metal at roughly 100 to 150 pounds per square is lighter than asphalt; tile at 800 to 1,100 pounds per square needs a structure designed for it.

Common mistakes when choosing between metal and shingle

  • Choosing on lifespan alone. A 40-year roof you sell in 8 years is not a 40-year investment.
  • Skipping the HOA check. Some HOAs restrict metal panels even where they allow Class 4 shingles, which Texas law protects.
  • Comparing a metal quote to a shingle quote without matching scope. Tear-off, underlayment and flashing must appear in both.
  • Assuming metal is hail-proof. It dents. It is the most hail-tolerant common material, not an invulnerable one.

When to call a professional

Call when you are weighing a material change, when your roof is past its realistic life, or when hail has hit your neighbourhood. In Stone Oak and Alamo Ranch, where 1990s and 2000s roofs are reaching replacement age, an inspection settles whether your structure and HOA suit metal, tile or shingles. Compare our metal roofing, shingle roofing and roof replacement pages, and more guidance is in our San Antonio roofing blog.

Choosing between metal and shingle? Call Juarez Contracting & Innovation LLC at (254) 329-0299 during business hours and we will compare them for your house. We serve homeowners in the San Antonio areas we cover.

Sources

  • UL 2218, Standard for Impact Resistance of Prepared Roof Covering Materials — the impact test behind Class 4 ratings.
  • National Weather Service — Bexar County hail reports, via the NOAA Storm Events Database.
Common questions

Good questions

Metal. Trade sources put standing-seam metal at 40 to 70 years and architectural shingles at a realistic 15 to 20 years in San Antonio. The gap is real, but so is the upfront cost difference.

Generally yes. Hail of 1 inch or more is the National Weather Service severe threshold and can damage asphalt shingles. Metal typically dents rather than cracks or loses granules, and standing-seam metal is the most hail-tolerant of the common materials.

A properly installed metal roof with underlayment and attic insulation is not notably noisy in rain, and light-coloured or cool-coated metal reflects more heat than dark asphalt. Ventilation and insulation matter more than the material alone.

Usually yes, because standing-seam metal is lighter than asphalt at roughly 100 to 150 pounds per square. But a re-roof still needs a City permit, and a change of material should be confirmed against the current re-roof application before work starts.

It depends on the HOA. Texas Property Code Section 202.011 protects certain hail-resistant and energy-efficient shingles from HOA bans, but it does not cover a switch to a different material such as metal panels. Check your HOA's design guidelines and get approval in writing.

Ready when you are

Ready to compare metal and shingle roofing for your home?

We inspect your roof, check its structure and HOA rules, and give you a written scope for each option. Call during business hours.

Call (254) 329-0299 →
↗
Emergency?Call now